Websydian v6.1 online documentationOnline documentation - Websydian v6.5

Websydian Server Properties

Introduction

The table below lists the parameters available for the Websydian Server property file. A sample property file (websydianserver.prop) can be found in the Websydian installation folder. 

Required parameters section

Websydian Server section

Parameter Default Value Description
websydianserver.ipaddr <default> The IP address of the machine where the Websydian Server is started. This address together with the tcpport is used by the Websydian Web Server Component to connect to the Websydian Server.

Examples:

websydianserver.ipaddr = <default>
websydianserver.ipaddr = localhost
websydianserver.ipaddr = 127.0.0.1

websydianserver.tcpport 8189 The TCP port of the Websydian Server. The port is used together with the IP address by the Websydian Web Server Component to connect to the Websydian Server.
websydianserver.password secret The password used when the Websydian Server is terminated. If blank or not specified the Websydian Server is considered to have no password.

If a password is specified the same password must be specified when terminating the Websydian Server using the TermServer command.

websydianserver.licensefilepath current directory The path and file name of the license file.

Log section

Parameter Default Value Description
log.level INFO The log level affects how much the Websydian Server will write to the log file. The following values can be used:
  • TRACE

  • INFO

  • WARN

  • ERROR

  • FATAL

Use ERROR in a deployment environment whereas TRACE should be used in debug situations only.

log.filename WebsydianServer.log The file to which the log is written.

Advanced parameters section

Log section

Parameter Default Value Description
log.media File The media where the log messages should be sent to. Legal values are:
  • File
log.rollfrequency ROLL_DAILY The frequency to be used by the log system to roll the log:

Valid values are:

  • NO_ROLL
  • ROLL_HOURLY
  • ROLL_DAILY
  • ROLL_WEEKLY
  • ROLL_MONTHLY
mail.smtphost no value If this parameter is specified all log messages of type FATAL will be sent in an e-mail to an administrator. This parameter specifies the host name of the SMTP server.
mail.subject no value The subject of the log mails.
mail.sender no value If mail.smtphost is specified, this parameter is mandatory and must contain the sender name to use when sending log mails.
mail.recipient no value The receiver of log mails.